Reboot and Reset Factory Default Settings on the WAP351

International Micro Village Incorporated

How Can We Help?

Posted
Last Updated On
ByInternational Micro Village Incorporated
You are here:
< < < Go Back

Objective

Rebooting a device is used to shut down and restart the device with a saved configuration. The factory default is used to restore the factory default configuration on the device to remove any previous configurations.

The objective of this document is to show you how to reboot your WAP351 device and reset it to the factory default.

Applicable Devices

• WAP351

Software Version

• 1.0.0.39

Reset to Factory Default

There are two ways to reset the Access Point to the factory default configuration:

• Hardware reset

• Reset with the use of the web configuration utility

Hardware Reset

Step 1. Press and hold the Reset button located at the back of the device for approximately ten seconds with a pin.

The Access Point reloads and is set to the default configuration settings.

Step 2. Login with the default credentials. The default username is cisco, and the default password is cisco.

Reset with the use of the Web Configuration Utility

Step 1. Log into the web configuration utility page and choose Administration > Reboot. The Reboot page opens:

Step 2. To reset the device, click the Reboot To Factory Default button.

A Confirm page appears:

Step 3. Click OK.

A Progress Bar appears:

Step 4. After the reboot is completed, login with the default credentials. The default username is cisco, and the default password is cisco.

Rebooting the Device

There are two ways to reboot the Access Point:

• Hardware reboot

• Reboot with the use of the web configuration utility

Hardware Reboot

Step 1. Press the Power button to turn off the device. After 10 seconds have passed, press the Power button a second time to power the device back on.

The Access Point reboots.

Reboot with the use of the Web-based utility

Step 1. Log in to the web configuration utility page and choose Administration > Reboot. The Reboot page opens:

Step 2. To reboot the device, click the Reboot button.

A Confirm page appears:

Step 3. Click OK to continue with reboot.

A Progress Bar appears:

Step 4. The Login Page appears. Login with the saved administration credentials.

Tags:
Table of Contents